← Back to Blog
November 14, 2026 · 5 min read

DJ Tech Rider and Stage Plot: What the Booth Needs

A DJ rider looks simpler than a band's. There's no drum riser and no 24-channel input list. But DJ sets go wrong in their own ways: a skipping turntable on a bouncy stage, booth monitors pointed at the dance floor, a mixer one model older than the one you practise on, or a table too low to work at for two hours. A clear tech rider and a simple stage plot prevent most of that.

Players and mixer

Name the exact models you want, and say what you'll accept instead. In many clubs the standard is a set of Pioneer DJ CDJ-3000 players with a DJM-900NXS2, DJM-A9 or DJM-V10 mixer, but plenty of venues still run older players. Write it like this:

"3 × CDJ-3000 (minimum 2 × CDJ-2000NXS2), linked. 1 × DJM-900NXS2 or DJM-A9. All players linked to the mixer over Pro DJ Link."

If you play vinyl, ask for turntables by model, commonly Technics SL-1200s, and say whether you'll bring your own cartridges and needles. Most vinyl DJs do, because worn house needles are a common complaint. If you play from a controller or laptop, say so, and ask for a flat surface wide enough for it next to the mixer, plus a power point there.

The booth itself

Booth monitors

Ask for a pair of booth monitors at roughly ear height, angled at the DJ position and not at the crowd, fed from the mixer's booth output so you control the level. On big stages, monitor engineers sometimes add side fills or in-ear monitors. If you want in-ears, say whether you'll bring your own receiver and pack.

Outputs to front of house

The mixer's master output goes to the front-of-house desk, normally as a balanced stereo pair on XLR. List it on your input list as two channels, left and right. If there's an MC or a host, put their microphone on its own FOH channel rather than into the DJ mixer, so the engineer can control it. If you want a recording, ask for a feed from the mixer's record output or from FOH.

Power

Ask for dedicated power at the booth, separate from lighting circuits if possible, with enough sockets for every player, the mixer, a laptop and phone charging. On international dates, check the voltage and plug type, and bring adapters for anything you carry.

What to bring yourself

Drawing the DJ stage plot

Even a one-person setup benefits from a plot. It should show where the booth sits on the stage, which way you face, where the booth monitors go, where the power is, and what's behind you (an LED wall, a backdrop or a band's backline under covers). If a band plays the same night, the plot also shows the promoter whether your booth can stay put during their set or has to be struck.

StageBuilder Pro has DJ gear in its Library: single and paired CDJs, turntables with a mixer, and a booth front panel, plus DJ setup templates to start from. Placing the DJ gear adds left and right channels to the input list automatically, so the FOH engineer sees the outputs they need to patch. A free account exports the plot and input list as a PDF for the promoter.

FAQ

What should a DJ tech rider include?

The exact players and mixer you want with acceptable alternatives, turntables if you play vinyl, booth size, height and stability, a pair of booth monitors fed from the mixer's booth output, a stereo feed to front of house, dedicated power, and a list of what you bring yourself.

How high should a DJ booth be?

Many DJs want the top of the gear at around waist to hip height, which is higher than a standard table. If you have a preference, give it in inches in the rider.

How do I stop turntables skipping on stage?

Keep the booth off any deck that also carries subwoofers, ask for a heavy braced table, and use isolation platforms under the turntables if the stage is bouncy.

Does a DJ need a stage plot?

Yes, even for one person. A simple plot shows where the booth sits, which way the DJ faces, where the booth monitors and power go, and what is behind the booth.

For the full advance, see from stage plot to full tech advance and how to write an input list.

Start from a DJ template, place the booth, and send the promoter a plot and input list in one PDF.

Open StageBuilder Pro →